How to judge the sealing of Engine Oil Tin Cans through pressure test?

Oct 11, 2024

Leave a message

1. Preparation
Choose appropriate pressure test equipment: such as airtight tester with pressure sensor and pressure gauge, which can accurately measure and display pressure changes.
Ensure the safety of the test environment: conduct in a well-ventilated room, avoid fire and static electricity, and testers wear protective equipment.
Prepare Engine Oil Tin Cans: remove the oil tank from the vehicle, empty the internal fuel and clean it, and check whether the appearance is damaged, deformed or corroded.
Install the test equipment: connect the interface of the pressure test equipment to the inlet and outlet of the oil tank or other suitable test points to ensure that the connection is firm and leak-free.
2. Test process
Fill the oil tank with a certain pressure of gas: usually compressed air is used, and the pressure is determined according to the design and use requirements of the oil tank, generally between 0.5-1.0MPa. Slowly increase the pressure through the pressure regulating valve, while observing the pressure gauge value, and stop inflating after reaching the set pressure.
Pressure stabilization stage: keep the pressure stable for a period of time after inflation, so that the internal pressure of the oil tank is evenly distributed, and the pressure stabilization time is not less than 5 minutes.
Check pressure changes: Observe the pressure gauge value closely during the pressure stabilization period. If the pressure drops beyond the specified range (such as a drop of no more than 0.05MPa per minute), there may be a leak.
Detect leak points: If a pressure drop is found, the leak point can be found by applying soapy water on the surface of the oil tank or using a professional leak detection spray. Bubbles or spray marks will appear at the leak.
3. Data analysis and judgment
Calculate the leakage rate: Calculate the leakage rate by formula based on the pressure drop value and the pressure stabilization time. If the leakage rate is within the specified range, the oil tank is well sealed; if it exceeds the range, it is unqualified.
Compare standard values: Compare the test results with the standards provided by the Engine Oil Tin Cans manufacturer or the industry general standards to determine whether the sealing meets the requirements.
4. Precautions
Check the equipment before testing: Ensure that the pressure test equipment is working properly and the accuracy is reliable, and calibrate the equipment to ensure measurement accuracy.
Follow the operating procedures: Strictly follow the equipment operation manual and test procedures to prevent erroneous results or safety accidents due to improper operation.
Multiple tests: To ensure the accuracy of the results, multiple tests can be performed, especially when problems are found in the first test or there are doubts about the results.
Analyze test results: If the oil tank is not sealed properly, analyze the reasons, such as defects in the oil tank itself, aging or damage of the seal, loose connection parts, etc., and take corresponding repair or replacement measures. After repair, test again until the sealing meets the requirements.